Conserte seus objetos Comunidade Loja

Versão renovada do iPhone 3G com velocidades de processamento mais rápidas. O reparo deste dispositivo é semelhante ao do 3G e requer simples chaves de fenda e ferramentas de abertura. Modelo A1303 / 8 GB,16 GB ou 32 GB de capacidade / Parte traseira em plástico preto ou branco.

1500 Perguntas Visualizar todos

Opções

Can the display connector on an iPhone 3GS be replaced?

I have a 3GS that has the digitizer connector damaged (2 pins at the very top have been broken off). As a consequence, any new screen put on the 3gs will fail to recognizer any touch. My main need is to extract the data out of the phone. I heard transferring flash chips is next to impossible, but the display connectors are attached to the logic board anyway. Is there any way to fix this?

http://i.imgur.com/cBktlLE.png

The picture is flipped upside down, so the missing pins are on the bottom

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

2 respostas

Filtrar por:
Mais úteis Mais recentes Mais antigas
Solução escolhida

Opções

Yes it is possible to replace this. Hot air station to desolder the old one, wick the old solder, and drag solder/pin by pin solder a new one on (using flux of course).

Connectors are available for these usually, or you can desolder one from a donor board by heating the other side of the board (to avoid melting the plastic on the connector)

Esta resposta foi útil?

Sim Não
Pontuação 2

2 comentários:

Wow that sounds incredibly complicated to solder pin by pin. I've only repaired screens of iPhones, so I've never done something near as complicated. i do have another 3GS I can use as a donor, but is there a more thorough Guide on how to do this?

por

I'm afraid not, it is literally a case of doing what I described above. Might be worth checking out iPad Rehab on Youtube, she replaces FPC connectors like this on newer models, which is basically the same process. You might be able to buy it new, I think we were able to get these back in the day when 3GS models were popular.

por

Adicionar um comentário

Opções

Yes it is possible but for that you need micro-soldering kit. secondly it is difficult to find display connector only for your iphone 3gs.

If you manage display connector from electronics part shop that it is fine.

if you not able to find connector then better to find any dead iphone3gs and desolder display connector from their.

So you can replace display connector.

Esta resposta foi útil?

Sim Não
Pontuação 0

2 comentários:

Could you point me in the right direction as to where I could get the soldering kit and what to do?

por

There are ready kit available for mobile iphone repairing and you can add needed tools as per your need. Go to any good electronics shop as we live in different country so difficult for me to guide you exact location for kit.

por

Adicionar um comentário

Adicionar a sua resposta

Bob Mcroy será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 68