Ir para o conteúdo principal

Second generation of iPhone. Model A1241 / 8 or 16 GB capacity / black or white plastic back. Repair is more straightforward than the first iPhone. requires screwdrivers, prying, and suction tools.

1158 Perguntas Visualizar todos

Direction of power button during asembly

I believe i am doing something wrong as my power button is depressed and won't move after I assembled it. Which direction should the lever on the power button move? One side moves completely flat versus the other side remains slanted

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação -1
Adicionar um comentário

6 respostas

Solução escolhida

hi birdie,

think i answered this a few days ago.. the silver ring hangs downwards and sits in a little groove on rear case. when you put the screws in make sure not to over tighten them- sounds like you've got one of yours tighter than the other. take button out and try again, if this doesn't work you might have to flip the button round (some have a right side and a wrong side) it's a tricky/fiddly fix and i sometimes do it several times before it finally works. good luck

Esta resposta foi útil?

Pontuação 2
Adicionar um comentário

The problem seems to be that is not reaching down and has no support and instead it sunkens down

Esta resposta foi útil?

Pontuação 0

1 comentário:

try a bit of tape to hold button in while you put screws in

por

Adicionar um comentário

It sunkens after i\I put the screws in and press the power button down. Any idas?

Esta resposta foi útil?

Pontuação 0

1 comentário:

Did you replace the rear cover? Your first question was after a drop

Can you post a photo of back case without button in? + with?

por

Adicionar um comentário

Yes I replaced the back cover, it looks identical to the original. I dont have a camera with me now. What are your thoughts?

Esta resposta foi útil?

Pontuação 0

1 comentário:

Just wondering if the place where power button fits hasn't been manufactured well enough to house power button. If the groove isn't holding the silver ring maybe this is why it is lopsided and not springing

por

Adicionar um comentário

I put a piece of tape, the screws and when pushed it still sunkens down. I give up

Esta resposta foi útil?

Pontuação 0

1 comentário:

have you tried a bit of tape wrapped around the silver ring to push it up a bit in the housing?

por

Adicionar um comentário

I could try that. I am trying to suspect I was sold the wrong button cause this thing just sits there and it shouldn't be this hard.

Esta resposta foi útil?

Pontuação 0

1 comentário:

quality of housings and fittings really varies. get back in contact with the supplier. if you bought off ebay then really read their feedback before buying. I've never had as much trouble as your having!!!!!

por

Adicionar um comentário

Adicionar a sua resposta

Birdie será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 659