Conserte seus objetos Comunidade Loja

A versão somente wi-fi do Air iPad, da Apple, modelo número A1474. Disponível nas cores cinza espacial ou prata, conta com o processador A7 personalizado, com configuração de armazenamento de 16, 32, 64, e 128GB.

299 Perguntas Visualizar todos

Opções

Problems after iPad digitizer replacement - boot screen, home button

Hi folks,

Just replaced a crushed digitizer on an iPad Air gen1, hurray for new things learned. However, after I did the tear down and put it back together I seem to have a few issues:

1) when I turn on the ipad after the apple welcome logo, it goes black unless I hold down the power button to shut it off. That's when I get the slide to power off screen. After I cancel that I get the "click home button to unlock" but that's when I discover my second issue...

2) the home button on my new front panel replacement doesn't seem to work. I took it apart a second time and made sure that the slide connector and the latch are securely in place and I put that little black tape that was on the original back and still the same thing. At first it wast sticky so I thought I had just put it together wrong so I took it apart and made sure there wasn't anything gumming up the button travel.

Thoughts anyone?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

1 resposta

Filtrar por:
Mais úteis Mais recentes Mais antigas

Opções

the new digitizer needs shielding. check jessa's post on her site iPad rehab where she talks about the iPad mini revealing it's secrets to her. you should get by with just shielding across the bottom of the digitizer on the inside, cover all the copper looking area. also if you check with the digitizer up not put down, I'm sure it behaves properly once booted up.

Update (01/26/2017)

could be a faulty home button, for sure a shielding thing with it working properly when up. are you sure that the home button was put in right? the gold part at the end of the home button flex needs to be facing up.

Esta resposta foi útil?

Sim Não
Pontuação 0

1 comentário:

Hi Richard,

Thanks for responding. I also didn't clean out the old adhesive very well so it's easy to take the thing apart still... guess I might need a new adhesive set. It was behaving fine with the digitizer up, so something must be happening when I'm sealing it up, or perhaps I'm pinching the LCD cable when I seal it up.

Though the home button still doesn't work even when the digitizer is up. Could it be a faulty home button assembly? I don't think I mis-treated it...

Thoughts?

-Gary

por

Adicionar um comentário

Adicionar a sua resposta

Gary Yee será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Duração total: 68