Small Blue Tinted Plastic Piece Fell Out While Disassembling iPhone 6

Question

iPhone xr

4994 Perguntas Visualizar todos

gybeho @gybeho

Rep: 43

3

Postado: 11 de jan de 2017

Opções

Small Blue Tinted Plastic Piece Fell Out While Disassembling iPhone 6

Replaced the digitizer screen successfully on an iPhone 6, however, during reassembly a small blue tinted piece of plastic fell out, and I don't know where it belongs. It is rectangular, has a corner cut off, and has two small holes in it. It is transparent, but tinted blue. It is pretty small, maybe 3 mm long or so. Might this missing piece have anything to do with the fact that the FF camera has a little bit of a halo on the image?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Adicionar um comentário

3 respostas

Josh W @joshw Rep: 12,1 mil 11 28 6 · Answer 1 · 2017-01-12T10:01:53-07:00

Pergunta mais útil

Josh W @joshw

Rep: 12,1 mil

11

28

6

Postado: 12 de jan de 2017

Opções

It sounds like the plastic piece that protects the glue where the microphone sticks on.

Esta resposta foi útil?

Sim Não

Pontuação 2

Adicionar um comentário

Darcy Patko @gomobilerepair Rep: 454 GoMobile Repair 3 1 · Answer 2 · 2017-01-11T13:51:37-07:00

Darcy Patko @gomobilerepair

Rep: 454

GoMobile Repair

3

1

Postado: 11 de jan de 2017

Opções

It must have been a leftover piece of protective film from the assembly process. There are not supposed to be any pieces of blue film inside of the iPhone 6.

The halo on your front facing camera likely means there was damage to it or there is some dirt or residue on the glass screen where the opening is.

Esta resposta foi útil?

Sim Não

Pontuação 1

1 comentário:

This small piece of blue plastic does not seem like temporary protective film. It looks more like it is designed to insulate one piece from contact with another.

I also doubt there is damage to the camera. Symptoms would be more severe than a slight halo along one edge. Dirt or residue is possible, but unlikely due to the care taken during the repair. Not my first rodeo. fixing these things. My own suspicion is the camera isn't securely back in the camera retaining socket, so it's an alignment or installation issue.

12 de jan de 2017 por gybeho

Adicionar um comentário