Rep: 49
3
1
Hi,
I bought Powerbeats 2 that as turned out have damaged cable. I opened them, desolder all the wire and I'm left with 9 of these.
How should I connect them?
CABLE/WIRES - https://postimg.org/image/9gzv7i5jb/
BATTERY - https://postimg.org/image/zdtjk496v/
BATTERY (connected after opening) - https://postimg.org/image/5zxt4j6h3/
HEADPHONE - https://postimg.org/image/qlh6a6dfr/
Esta é uma boa pergunta?
Rep: 2,4 mil
17
10
10
Here are the original wire locations:
Esta resposta foi útil?
Where's the main circuit board that the mic and volume controls are on that have the I wanna say 5 but possibly 6 different wires soldered to it!???
sorry for the delay Clint here is the image. the wire between the blue and yellow is black if you can't tell in the image. It appears to only be 5 wires soldered, the 6th solder pad appears to be unused.
Thank you so much, never would've gotten this soldered correctly without those, you're a life saver!
Rep: 13
1
Thanks you so much.
But could you please help me to let me know the Cable in Right Speaker (while and red-green) connect with what color in the long cable.
Thanks you so much guys.
Esta resposta foi útil?
I posted the answer to this I believe right above, please take a look...thanks
Hello sir, i have same problem with clint. I soldered the 3 wires in battery and it works.. But there are 3 more wires. The yellowred, the black, and the greenred..How do i connect for the right earbuds. Hope you're immediate response..
If this was for me, sorry for the delay...please post against my answer and you will get a quicker reply. Again the images are all above for every wire in the system
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 7
Duração total: 6,675
