Rep: 1,6 mil
12
5
3
Customer brought in an iPad Pro 12.9" with a cracked screen. I replace the screen and soldered the new one on properly 100%. Customer has issues with the dead spot on the screen. So I ordered a brand-new digitizer assembly and install that one. Exact same issue as the first one. Anybody have any suggestions? No apparent damage to the control board and soldering is good. Thanks!
Esta é uma boa pergunta?
Rep: 1
1
then the controller board is bad, simple
sounds to me like proccess of elimination its the controller board, too much heat, etc can damage a controller board, hope you find a solution.
Esta resposta foi útil?
Rep: 61
3
lcd is not ok failure
Esta resposta foi útil?
LCD is perfectly fine on both. Ordered from 2 separate manufacturers, dead spot in same exact area.
Últimas 24 horas: 0
Últimos 7 dias: 1
Últimos 30 dias: 3
Duração total: 476
Same supplier? Seconds?
por mayer
Different Supplier. LCD is good on both.
por GadgetERService