Why doesn't my new battery work?

Question

iPhone 2G

The first model of iPhone, Model A1203 with 4, 8, or 16 GB capacity and an aluminum back. Repair requires a significant amount of prying, and may require some soldering. This page aims to help users troubleshoot, fix, and seek help for the iPhone 2G.

224 Perguntas Visualizar todos

andrewvoelker @andrewvoelker

Rep: 1

1

Postado: 30 de set de 2010

Opções

Why doesn't my new battery work?

I went through the instructions. Getting the case off was difficult. De-soldering and re-soldering the battery went smoothly.

After re-assembly, I put the iPhone 1st gen into a dock to charge. It simply flashes the start screen (apple on black background) -- about 5 seconds on and 2 seconds off.

Perhaps the soldering wasn't perfect? Perhaps there's some other physical problem?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação -1

Adicionar um comentário

2 respostas

russcurtis @russcurtis Rep: 13 1 · Answer 1 · 2010-10-24T13:28:02-07:00

Pergunta mais útil

russcurtis @russcurtis

Rep: 13

1

Postado: 24 de out de 2010

Opções

I have the same problem. I checked the new battery voltage and it is only .245Mv, therefore, I think it's a bad replacement battery. The old battery shows 3.79V. So, I think I will try putting the old battery back into the phone and check again.

Esta resposta foi útil?

Sim Não

Pontuação 1

2 comentários:

+ sounds like a good plan to check voltage of batteries

12 de nov de 2010 por pollytintop

Yes, it was just a bad battery. ifixit quickly sent a replacement and the new battery worked fine.

12 de nov de 2010 por russcurtis

Adicionar um comentário