Ir para o conteúdo principal

Touch ic problems iPhone 6plus

So i got a iPhone 6 plus today with the grey bar on top indicating that the touch ic was going bad, or not soldered well. i have replaced the cumulus chip and now i have no grey bar, but the touch is a little less responsive near the letter U if you were texting. or trying to slide backlight brighter 3/4 of the way it stops.

Do you think this is a problem with the chip i replaced or is this caused by the mason chip?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0

1 comentário:

Is the screen that is on the phone right now have any signs of physical damage at all?

por

Adicionar um comentário

2 respostas

Screen could possibly been replaced. It is known to happen that the Touch ID will stop working once a screen is replaced. Part of the deal made when the lawsuit happened over Error 53 (source: TechCrunch).

Esta resposta foi útil?

Pontuação 0

1 comentário:

The reason the Touch ID isn't working after the screen replacement is only because of two reasons;

1. the home button was damaged during the repair.

2. the home button flex cable was damaged during the repair.

I saw it happened only was when the Touch ID stopped working after a repair for no reason on an iPhone 5S and after I reset all the settings (in settings) it was fully working again.

por

Adicionar um comentário

first of all try to install a new screen to see if it helps. there is no harm in trying a new screen.

if it didn't help any, try re-soldering the chip back in the place, maybe you missed something while soldering the IC. if yet it's not solved then I think it safe enough to say that It is indeed the touch IC.

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

Jessica Ward será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 1,061