Rep: 11
1
I was soldering off the battery terminals and the last pad came off. How can I fix this? I no longer have the old battery with the pad on it.
Thank you in advance.
Esta é uma boa pergunta?
Rep: 782,2 mil
1,1 mil
893
2,3 mil
Ronni Denny you most likely cannot. the solder pads are actually solder to the traces. If you would use a microscope and a very fine needle and carefully scrape the top layer material where the original pad was, you'd find a connector right about in the middle of the pad. Anyhow, your only option will be to try to solder a wire from the battery connector to a trace from that pad. Clean your board and give us another picture which is straigh on and a bit closer.
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 135
3 comentários
Ronni Denny post some images of the damage with your question so we can see what you see. Use this guide Adicionar imagens a uma pergunta já existente for that
por oldturkey03
I added the photo.
por Ronni Denny
I also have another iPod touch 4th gen logic board that has all of the pads on it, could I possibly use one of those pads on this iPod?
por Ronni Denny