Conserte seus objetos Comunidade Loja

Updated version of the original iPad 2, released in March of 2012 with a smaller die processor and updated internal construction. Repair will require the use of heat and careful prying.

73 Perguntas Visualizar todos
Pergunta encerrada

Opções

New Screen Cover Not Sticking

Hi, I replaced the volume/audio ribbon and dock connector in my iPad2. After finishing everything and putting the new glass cover, everything worked great, looked great, was happy. But I noticed that after a short while, the edge of the glass cover is peeling off and separating from the edges (pic).

Block Image

The new screen had pre-applied 3M 300LSE tape. I really don't want to risk removing the screen and breaking it... what are my options?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

1 resposta

Filtrar por:
Mais úteis Mais recentes Mais antigas
Solução escolhida

Opções

That tape is useless try using this instead Red Tape you wont break the screen if you use that 3M 300LSE tape you applied use a heat gun to remove the screen you will be fine.

Esta resposta foi útil?

Sim Não
Pontuação 2

2 comentários:

Thanks for this. Will try to find locally, not sure if I can. All these shipping charges and exchange rates is adding up!

por

Finally got the 5mm red tape. I didn't need to use the heat gun to remove the screen, it popped right out (that adhesive was very cheap indeed). Applied the red tape, left overnight and glass was still as it should this morning. Winner. Smartcover sensor not working, but I can do without.

por

Adicionar um comentário
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 122