Rep: 11
1
I replaced the screen on my gold 6 plus, I decided to put a black screen on Iit and everything went well until I turned the phone on and the screen was unresponsive to touch. Before complete installation I did test the screen and it worked . The screen has light lines running down the screen please help
Esta é uma boa pergunta?
Rep: 102,5 mil
18
191
304
I would take the phone apart again and get it to were it worked before then re assemble slowly and with care checking when possible if it works to know when things go wrong.
Esta resposta foi útil?
Rep: 2,2 mil
4
4
1
Sounds like the digitizer flex cable or socket on the board may be damaged. I would inspect those areas under a microscope.
Esta resposta foi útil?
Could also be a short , did you put all the insulating tape back on?
When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through
Rep: 1
5
4
Your digitizer flex isnt properly plugged in most likely.
Esta resposta foi útil?
When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through
Rep: 109
3
2
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 328
2 comentários
Does the home button work?
por Jimfixer
I didn't attach the home button backing plate yet because I have a stripped screw and ordered a new plate, but the touch id was still funtioning
por Josh B