When replacing the home button gasket i noticed that there's still a very thin and even square of the old gasket attached. Should the surface be completly clean (danger of scratching the surface or removing only partialy) or is it safe to glue on top?
Esta é uma boa pergunta?
Rep: 37,6 mil
22
51
42
I take it your talking about the rubber gasket if yes then just use a little heat and pick off with tweezers and yes area should be clean
Esta resposta foi útil?
I imagined that was the correct way to do it. I was just trying to avoid any possible problems during the ungluing.
Thanks.
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 72
