Ir para o conteúdo principal

display on/off-sensor placement / clamshell mode

Hi .. I want my MacBookpro to run in permanent clamshell mode without needing to close the display. I thought I could just trick the open/close sensor system or so

any idea? where is that bugger, in the hinge?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

4 respostas

Pergunta mais útil

Located on the back of the right side of the keyboard, about in the middle.

It is commonly called a reed switch. By sliding a paperclip along the bezel bottom you can locate the magnet in the bezel. Placing a magnet on the top case in the correct position will "sleep" the display.

If this answer is acceptable please remember to mark it.

Good Luck,

N.

Esta resposta foi útil?

Pontuação 1

1 comentário:

Genius. Trying to figure this out for years. Even the IT guys I was working for didn't know.

por

Adicionar um comentário

I have a MBP with a busted screen (backlight working). It's hooked up to a studio diplay that is configured as main monitor in system preferences. The MBP display doesn't do a thing now, neither open or closed. No need to trick any sensors.

Esta resposta foi útil?

Pontuação 0

2 comentários:

but is it still in the system prefs? i hate saerching for windows that are located on a second screen thats switched off

por

Once the external display is configured as main all windows are displayed on it.

por

Adicionar um comentário

ok .. it seems to be in the screen on the right side of the camera and the little hook thingy that keeps the cover down. attaching a magnet there sends my MacBookpro to sleep

thanks machead3

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Had this happen on an A1278; couldn’t figure out why. Magnetized USB connectors were the problem. Demagnetize them with something like this: https://amzn.to/2CEM4pJ

There are 4 strong N or S domains on the upper display border by the camera, starting about 2” from the outer edge of the display clamshell and ending about 3-4” inches in, on both right and left sides. This makes me think there’s either 1 or 2 clamshell sensors (hall or reed type) in the palm rest on either side of the trackpad.

pmset -g log:

Display is turned off

Entering Sleep state due to 'Clamshell Sleep' …

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

kay k será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 4,270