Ir para o conteúdo principal

iPhone de quarta geração lançado em 2010. O reparo é simples, mas o vidro frontal e o LCD devem ser substituídos juntos, como uma unidade. GSM / 8, 16 ou 32 GB de capacidade / Modelo A1332 / Preto e Branco.

2375 Perguntas Visualizar todos

How to attach battery connector back to logic board?

I changed the front screen on my iphone and put the battery back in but it wouldn't charge. I replaced the battery but the connector wasn't there, it was still attached to the old battery. Can I reattach it? If so how?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação -1
Adicionar um comentário

1 resposta

Solução escolhida

Bev, you can either try to solder it back on, depending on what the traces look like, or you can run some jumper connections. Either way will require some fine soldering. If you decide to run jumper wires, bridge the points with the smallest wire you can find and use the image as a guide. Reroute any wire so that they are not in the way with the re-assembly. Take a look at this video as well as on here. Both videos show it very well. Because of the intricacy of the solder on the board, I suggest that you practice first, or have someone solder it for you. Hope this helps, good luck.

Block Image

Esta resposta foi útil?

Pontuação 1
Adicionar um comentário

Adicionar a sua resposta

Bev será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 376