Rep: 591
12
36
5
This iMac wont turn on. No start up sound, no video, no fan, totally dead.
The LEDs on the logic board don't show any light.
I guess is the power Supply, but before buying a new one, I would like to test it. Is there any way to do it?
Thank you
Esta é uma boa pergunta?
Rep: 479,2 mil
35
329
971
Here's the iFixIt guide to replace the power supply for this model Power supply. I would first make sure the AC in & DC out cables where not loose. Then I would check for any visibly damaged components.
If I didn't see anything I would do a little probing to check if the power button was working and check logic board was getting voltage. At this point you would need to have the system powered to check anything. Otherwise, I would just swap out the supply
CAUTION you can hurt your self as well as your system if you don't take proper steps. Ideally, you should have an isolation transformer to protect your self from the direct line voltage. In addition placing the probes directly on the power supply when you don't know what you are touching could damage it and the main logic board.
Esta resposta foi útil?
Rep: 685,3 mil
3,4 mil
1,1 mil
2,6 mil
Your machine may still be under warranty. Go here and enter your serial number to see if it is:
Esta resposta foi útil?
+ Hey Mayer, hope all is well in your world. I haven't been on here or seen you in a while.
The warranty is expired.
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 3
Duração total: 3,400
4 comentários
Double check your line cord first. Otherwise no real way without a DVM to test the voltages. What happened with it? did it work and then stop?
por Dan
LIne cord is ok. iMac was working ok and suddenly stops. Is a DVM a Multimeter?
por Flavio
Yes, a multimeter will work (D - Digital, V - Volt, M - Meter)
por Dan
NOw the big question since I use the DVM only to test batteries, do you know how to use to test this power supply? Or if you know is there any web site with pictures? Thank you very much
por Flavio