Conserte seus objetos Comunidade Loja

iPhone de quarta geração lançado em 2010. O reparo é simples, mas o vidro frontal e o LCD devem ser substituídos juntos, como uma unidade. GSM / 8, 16 ou 32 GB de capacidade / Modelo A1332 / Preto e Branco.

2375 Perguntas Visualizar todos

Opções

How to apply a jumper to the blue inductor?

hello DEAREST @johnkustic PLEASE HELP me

how can i jumper it ? please ?

recieved iphone 4 after water damage with erro -1 in itunes

now its fixed

but constently losing wifi/gsm signal

the phone has imei and all ,please help me if you can

?

with what wire can i use to jumper it,its too close to another fuse ,

you saID YOU made a jumper with soldering iron ,since its too small i guess you only implemented soldering iron and thats it ?

can it also be the bb or other coil?

can you please answer me ?

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação -1
Adicionar um comentário

2 respostas

Filtrar por:
Mais úteis Mais recentes Mais antigas
Pergunta mais útil

Opções

Hey 7Gnosis Sorry for late reply did not see your post. Just use regular soldering iron, soldering wire and no clean flux. Just apply little bit of flux and after melt soldering wire to connect the two points where blue coil is missing.

Hope that helps.

Esta resposta foi útil?

Sim Não
Pontuação 3

2 comentários:

@Johnkustic

Hi, a have a same issue. crap blue coil is missing i have solder a Jumper today but no luck. still no Service /Searching may be is wrong soldering. Do U have any pix with the Jumper on this Place . I tried with conductivity silver before there was the same will try again tomorrow

thank you Etienne

por

Thanks John, works like a champ! A customer of mine damaged her phone with a home repair. I did not need to run a wire as posted by some others. Simply cut a piece of small solder and laid it where the blue coil once was and voila.

por

Adicionar um comentário

Opções

The answer to your questions, how to fix the blue inductor coil causing a signal problem, the solution is easy we have repaired many with a 100% success rate. If you look at the signal antenna which you plug the cable into, simply run a wire from the left side bridge it to the right side point on the blue coil and follow it all the way to the furthest (right) component on the top left side. This will act as a 'bypass route' and your signal will start to work again.

All it takes is a bit of micro-soldering knowledge and some 0.1mm wire and basing soldering equipment. This will fix your problem guaranteed, providing it was the missing blue coil that caused your signal issue in the first place.

Kind regards,

Ideal mobiles

Esta resposta foi útil?

Sim Não
Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

7Gnosis será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 2,157