Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Ajuda

Mensagem original de: Chris Stables ,

Texto:

It looks like the tracer pads have been removed while heating or soldering. It is fixable but you will need to run two jumper wires from the switch pins to where they end up on the circuit or scratch the board to reveal the traces and solder a wire from there to the pins. You will have to make sure the switch is fastened properly as it will not be soldered to the board on that section.

 It’s a nice looking project for you.

Status:

open