Pular para o conteúdo principal
Ajuda

Versão atual de: Paul Hewitt ,

Título:

How to remove the side panel of a Canon Pixma MG5622

Texto:

My Canon Pixma MG5622 printer was displaying the "ink absorber is almost full" warning and is now not allowing the ink cartridges to move out of the way so that I can access and clean them as I'm educated on simply how to. I want to remove the side panel only I can't seem to figure out how. There are the arrows pointing to slots for a flathead screwdriver to loosen it up. Unfortunately there is one at the front that I can't figure out and I don't want to break the thin plastic. I can't get seem to get any answers from Canon unless I pay for the repair service which would cost more than I paid for the printer. This happened before with a paper jam that luckily YouTube had a simple tutorial showing what lever to press etc. Any advice would be greatly appreciated!

dispositivo:

Canon Printer

Status:

open

Resposta Aceita:

484774

Editado por: Paul Hewitt ,

Título:

How to remove the side panel of a Canon Pixma MG5622

Texto:

My Canon Pixma MG5622 printer was displaying the "ink absorber is almost full" warning and is now not allowing the ink cartridges to move out of the way so that I can access and clean them as I'm educated on simply how to. I want to remove the side panel only I can't seem to figure out how. There are the arrows pointing to slots for a flathead screwdriver to loosen it up, unfortunatelyup. Unfortunately there is one at the front that I can't figure out and I don't want want to break the thin plastic. I can't get seem to get any answers from Canon unless I pay for the repair service which would cost more than I paid for the printer. This happened before with a paper jam that luckily YouTube had a simple tutorial showing what lever to press etc. Any advice would be greatly appreciated!
My Canon Pixma MG5622 printer was displaying the "ink absorber is almost full" warning and is now not allowing the ink cartridges to move out of the way so that I can access and clean them as I'm educated on simply how to. I want to remove the side panel only I can't seem to figure out how. There are the arrows pointing to slots for a flathead screwdriver to loosen it up, unfortunatelyup. Unfortunately there is one at the front that I can't figure out and I don't want want to break the thin plastic. I can't get seem to get any answers from Canon unless I pay for the repair service which would cost more than I paid for the printer. This happened before with a paper jam that luckily YouTube had a simple tutorial showing what lever to press etc. Any advice would be greatly appreciated!

dispositivo:

Canon Printer

Status:

open

Postagem original de: Paul Hewitt ,

Título:

How to remove the side panel of a Canon Pixma MG5622

Texto:

My Canon Pixma MG5622 printer was displaying the "ink absorber is almost full" warning and is now not allowing the ink cartridges to move out of the way so that I can access and clean them as I'm educated on simply how to. I want to remove the side panel only I can't seem to figure out how. There are the arrows pointing to slots for a flathead screwdriver to loosen it up, unfortunately there is one at the front that I can't figure out and I don't want want to break the thin plastic. I can't get seem to get any answers from Canon unless I pay for the repair service which would cost more than I paid for the printer. This happened before with a paper jam that luckily YouTube had a simple tutorial showing what lever to press etc. Any advice would be greatly appreciated!

dispositivo:

Canon Printer

Status:

open