Pular para o conteúdo principal
Ajuda

Versão atual de: William Thompson ,

Texto:

I have (had, fingers are crossed) the same problem until 50 minutes ago. I can explain how to get to the end of the directions above if you like.
 
=== Update (07/10/2017) ===
 
Okay, here goes. I'll start from normal/standby mode
 
1. Enter the maintenance/diagnostics mode. Refer to the video to help you if you don't know how.
 
https://applianceassistant.com/appliance-repair/whirlpool-belt-drive-washer-repair-guide/
 
2. Rotate dial cw to the rinse position, the rinse LED light should be illuminated. You are ready for calibration.
 
3. Press the start button. Following the original directions from Mayer above. Make sure there is no clothes or remaining water prior to calibration. Do not disturb the washer until the self test is complete, approx 4 min. I ran the calibration a few times before I was successful.
 
4. Once, I ran a good calibration, I entered maintenance/diagnostics mode again. This time I entered diagnostics mode (refer to video link about 3 minutes in) I stepped through each dial position. I may be incorrect but I related this procedure to Mayer's "cycle selector knob each click "indent" toggles the "done&quot". And unlike other attempts, this time I did not have any faults.
 
5. Once I got through the diagnostic with out faults I exited by pressing cancel.
 
6. I returned to my regular was setting and it ran successfully and now shows complete and it has been 3+ hours without a restart.
 
I hope this helps.

Status:

open

Postagem original de: William Thompson ,

Texto:

I have (had, fingers are crossed) the same problem until 50 minutes ago. I can explain how to get to the end of the directions above if you like.

Status:

open