Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos



Mensagem original de: Jon ,


Once a phone gets wet we focus on saving the data and not saving the device. Too many things can still fail on the phone after a liquid damage repair is done. Because of that we focus on saving the data on the phone.

We will first take the logic board out of the phone and put it through an Ultrasonic Bath which makes connections work again that would not work for any other reason. We will then inspect the board under a microscope looking for burns or obvious problems.

We then find those problem components on the schematic to learn what that component does. Then we carefully heat and remove the old components and clean the area to get it ready to take the new component. We will solder the components into place in order to get the phone to give up its data.

Often we can get the phone working just long enough to grab the data or make a backup.

It is a pretty difficult repair and it is not always successful.