Pular para o conteúdo principal
Ajuda

Versão atual de: Rany ,

Texto:

Here's a similar one I did, on a 6S Plus. Just saying that anything can be done if you put your brains and skill to it. It may not be economical, but it is doable.
 
https://www.facebook.com/microsoldering.repair/posts/1335786369828880
 
(I hope this is not considered spam, I just have a hard time uploading pictures here because of my snail Internet).
 
You can even glue the driver in a different location and run jumpers. You'll need to be able at least to solder to a stub of the traces going underneath the CPU. Everything else is otherwise doable if you think out of the box.

Status:

open

Editado por: Rany ,

Texto:

Here's a similar one I did, on a 6S Plus. Just saying that anything can be done if you put your brains and skill to it. It may not be economical, but it is doable.
 
https://www.facebook.com/microsoldering.repair/posts/1335786369828880
 
(I hope this is not considered spam, I just have a hard time uploading pictures here because of my snail Internet).

Status:

open

Postagem original de: Rany ,

Texto:

Here's a similar one I did, on a 6S Plus. Just saying that anything can be done if you put your brains and skill to it. It may not be economical, but it is doable.

https://www.facebook.com/microsoldering.repair/posts/1335786369828880

Status:

open