Pular para o conteúdo principal
Ajuda

Postagem original de: mayer ,

Texto:

Sounds like it needs to be recalibrated.  Here's how:

http://www.searspartsdirect.com/partsdirect/part-model/Washer-Parts/Washer-Parts/Repair-Maintenance/Questions-Answers/how-to--do--diagnostic-cycle-or-calibrat/Model-11021302012/0582/0153200/394273?modelNumber=11021302012

To access calibration mode, turn the cycle selector knob until the status LEDS correspond as follows:

Rinse LED (ON)

Press the START button to begin washer calibration.

All status LEDS will turn on

DO NOT INTERRUPT CALIBRATIONS

Lid must be down to perform the test and the basket must be empty to perform tests. Calibration cycle will run 2-4 minutes. Cycle completes when door unlocks and washer enters stand by mode

When that is all done Calibrate the User Interface.

Turn on all the LEDS like you did for the motor calibrations

When rotating the cycle selector knob each click "indent" toggles the "done" after all 5 LEDS have lighted up.

1st click Fill

2nd click Wash

3rd click Rinse

4th click Spin

5th click off

Status:

open