Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos



Mensagem original de: Kari ,


While the die set is a fabulous addition to any  repair techs tool box,  there is a cheaper solution.  If you have a radius gage set the corners can be measured and then the specs can be brought to a machine shop and they can cut on a mill,  a block that you can use like a dolly.  Slide it in to the corner and a few taps should straight it out.  You can also have the machine shop create a inner and outer die set too.  This should be very cheap since it's not a very intricate cut.  You can always have a set made when you need it rather than buy a 350$ tool you may use a half a dozen times,  unless you can afford it...