Ir para o conteúdo principal
Ajuda

Versão atual de: Errol ,

Título:

Thermal Pads vs Arctic Silver

Texto:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

dispositivo:

PowerBook G4 Aluminum 15" 1-1.5 GHz

Status:

open

Resposta Aceita:

+44304

Editado por: David Hodson ,

Título:

Thermal Pads vs Arctic Silver

Texto:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

dispositivo:

-Powerbook G4 FW800
+PowerBook G4 Aluminum 15" 1-1.5 GHz

Status:

open

Mensagem original de: Errol ,

Título:

Thermal Pads vs Arctic Silver

Texto:

I'm going to need to replace the right blower on a PowerBook G4 FW800.

The instructions indicate that I have to remove the logic board so I'll need new thermal pads.

However, I was wondering if anyone has experience using arctic silver instead of the official thermal pads.

My guesstimation is that arctic silver applied properly would likely out-perform the pre-made pads however the heat sink may rely upon the spacing defined by the pads.

Anyone have suggestions?

dispositivo:

Powerbook G4 FW800

Status:

open