Pular para o conteúdo principal
Ajuda

Postagem original de: x10target ,

Texto:

Mr. Mayer must not have reassembled one of these prior to his answer in 2010, regarding your problem with the antenna plate.

The plate has a tiny lip that must fit into the case precisely.  It is very difficult to adjust into proper alignment. The most successful maneuver I have found is to slide the plate into a loose, ready position.  Then, instead of sliding straight towards the top of the case (where the 2 dots are), slide the plate at a slight diagonal to the right with enough pressure for the entire lip to ease into place.

This may take a couple of tries to get right.  When it is, you'll be rewarded with a slight "Thunk!" as both ears slip into place on either side.

Then screw in the two 5mm T8 Torx screws first, then the Two 6.6mm T8 Torx screws.

Status:

open